Fying cold saw adopts Siemens' most advanced digital motion control system, which has short response time of multi-axis control, flexible acceleration and deceleration, and perfects the high-precision synchronous tracing sawing of steel pipes.
The flying cold saw bases is equipped with inlet guide rollers (upper and lower, left and right rollers), the front end of the fixture is equipped with auxiliary guide rollers, and the final discharge position is provided with supporting rollers, all supporting rollers help the parallel movement of the pipe in the sawing process. Both ends of the saw body are equipped with car safety bumpers. Sawing method: Saw blade and feed can be adjusted, that is to say, feed servo motor speed can be changed, saw blade speed can be changed, thus greatly improving the utilization rate of saw blade.
Advantages
Safety
Low noise, good production environment, low spindle rotation and high safety factor
Excellent performance and high production efficiency
The cutting has good flatness, no burr, no need for flat head or CNC cutting, high cutting efficiency and low loss.
Intelligent operation
Friendly operate interface, clearer and simpler control, richer information, and simple settings for excellent cutting results.
Low maintenance costs
Flat cut, no burr, no secondary processing, stable equipment performance, optimized operating curve to ensure minimum mechanical wear, reduce downtime, and lower average cost.
Flying cold saw through the 4G network, it realizes 24-hour remote online diagnosis, fault inquiry, fault repair, program update and download functions, and realizes unattended after-sales service for users. Efficiently and quickly solve the worries behind.
Other type ordinary hot cut flying saw
The noise is high, the production environment is bad, the spindle speed is high, the safety factor is low, and safety accidents are easy to occur.
The cutting burr is large, requires flat head, pneumatic or hydraulic drive cutting, low cutting efficiency and large loss.
There is less information on the operation interface, it is difficult to judge the state of the device, and the cutting effect cannot be changed.
The cut burr is large, secondary processing is necessary. The mechanical equipment has large impact, easy to form wear, increase downtime, and the subsequent average cost is high.
|
Model
|
Dia mm
|
Thickness mm
|
Speed m/min
|
|
32
|
8-50.8
|
0.3-2.0
|
120
|
|
50
|
14-63
|
0.5-3.0
|
120
|
|
76
|
32-102
|
0.5-4.0
|
80
|
|
89
|
32-110
|
0.5-5.0
|
60
|
|
114
|
40-127
|
0.5-5.0
|
50
|
